Owners Manual
2800 Series Marquee
3.2.5 Set Insert Data [ESC][CTRL-N][location][CTRL-D][CTRL-E]
Address Header Entry
Start
Number
Start
Location Number Insert
Data
End
Entry
CTRL-B A ESC CTRL-N 0 0 1 CTRL-D CTRL-E
02h 41h 1Bh 0Eh 30h 30h 31h 04h 05h
• Address Header – directs the command to the specified marquee. To send the command to a different
marquee, change the second character of the address header to the address of the marquee you wish to send
the command to. If you have disabled the addressing feature of the marquee, do not send the address header
section.
• Entry Start – puts the 2800 into entry mode, which is used to enter data into the marquee.
• Number Start – tells the marquee that the entry will be a three digit location number.
• Location Number – specifies the three digit location number. This section must be exactly three characters
long, and all three characters must be numeric. Valid location numbers range from 001 to 009.
• Insert Data - instructs the 2800 to copy the contents of the text entry buffer to one of the RAM insert data
buffers. The previously supplied location number specifies which insert data buffer to overwrite.
• Entry End – ends message entry mode.
The insert data feature allows the insertion of variable data into an EEPROM stored message. Embed a
[CTRL-D][n] sequence within the stored message text. The [n] character specifies which of the nine insert
data buffers to insert into the message, and may range from [1] to [9]. When the message is displayed on the
marquee, the [CTRL-D][n] characters are replaced by the contents of the specified insert data buffer.
To store a message with with embedded insert data, send the following command sequence:
1 – enter message text. [CTRL-B][A][ESC][Finished Units:][CTRL-D][1][CTRL-E]
2 – store message in EEPROM. [CTRL-B][A][ESC][CTRL-N][0][0][1][CTRL-A][CTRL-E]
To set the contents of an insert data buffer, send the following command sequence:
1 – set invisible entry flag. [CTRL-B][A][CTRL-I]
2 – enter variable data. [CTRL-B][A][ESC][15 Cars][CTRL-E]
3 – set insert buffer [CTRL-B][A][ESC][CTR-N][0][0][1][CTRL-D][CTRL-E]
After issuing the above commands, recalling stored message 001, will display: Finished Units:15 Cars
To change the inserted variable data send the following command sequence:
1 – set invisible entry flag. [CTRL-B][A][CTRL-I]
2 – enter variable data. [CTRL-B][A][ESC][16 Cars][CTRL-E]
3 – set insert buffer [CTRL-B][A][ESC][CTR-N][0][0][1][CTRL-D][CTRL-E]
After issuing the above commands, the displayed message will change to: Finished Units:16 Cars
Note: The insert data RAM buffers are only 30 characters wide, do not exceed this limit!
PB-2149-335B Page 35
(12 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern