Moxa NPort Express DE-311
Moxa Corporation
The NPort DE-311 is a serial server that
provides RS-232 to Ethernet conversion
and transport of serial data over an IP
network. The DE-311 does not meet the
NEMA TS2 temperature specification.
Directions included below may also be
found in the NPort Family Software
Installation Guide that is shipped with the
DE-311. The manual is also available on
the Moxa website at
http://www.moxa.com/product
.
The NPort DE-311 comes with
configuration software. Use of it can
greatly simplify the installation and
configuration process. Refer to the
installation guide for additional
information on the NPort Management
suite. The suite contains two individual
programs: Configurator and Real COM
Installer.
Cabling
The DE-311 has a DB-9 connector for the
serial port on the bottom edge. Use the
standard serial cable as described on
page 3. In addition, this device requires a
DB-9 Male to Male adapter and a null
modem adapter to connect the two serial
ports together.
Network Configuration
The DE-311 must be setup to ensure the
proper serial port settings are configured
to communicate with the Opticom™
Infrared phase selector over the RS-232
interface and that the proper network
configurations are made to allow the DE-
311 to be found on the network by the
central management software. The unit
must be configured with a static IP
address.
Specify the IP address to be used by this
device.
Specify the Subnet Mask (usually
255.255.255.0).
Specify the Default Gateway.
Specify IP Configuration as Static IP.
Specify the Access Control list to control
by IP Address and add in specific IP
addresses or group ranges.
Refer to the Section 5 of the NPort Family
Software Installation Guide for
instructions on how to access the
configurations via the webpage interface.
Serial Port Configuration
The serial port configuration consists of
selecting the Serial Settings from the
webpage.
Configure the Basic Serial Port
Configuration settings as described in the
Required Serial Settings on page 3.
The Operating Mode specifies the type of
transport communications means which
will be used to ferry the RS-232 serial
data over the IP network. Central
management software supports TCP
sockets and Real COM profiles.
Select Operating Mode to:
• Real COM Mode for COM port
redirection,
• TCP Server Mode to use TCP
sockets.
When Real COM mode is used, the COM
port must be mapped using the Real
COM Installer which is a separate utility
independent of the Management
software.
Refer to the NPort Family Software
Installation Guide for instructions on how
to access the configurations via the
webpage interface or via the NPort
Management Suite.
(25 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern