RMC-30 Ruggedcom Corporation
The RMC-30 is a serial server that
provides RS-232 to Ethernet conversion
and transport of serial data over an IP
network.
Directions included below may also be
found in the RMC30 Installation Guide
and the ROS User’s Guide for RMC30
along with more detailed information
about the device. Both documents are
shipped with the RMC-30 and are
available on the Ruggedcom website at
http://www.ruggedcom.com.
Cabling
The RMC-30 has a terminal block for
terminating the RS-232 serial connections
and the RJ-45 Ethernet connector on the
front of the unit. Refer to the RMC30
Installation guide for the wiring directions
to make a custom cable and
terminations.
A standard Ethernet cable should be used
for connecting the Ethernet port to your
network.
Network Configuration
The RMC-30 must be setup to ensure the
proper serial port settings are configured
to communicate with the Opticom™
infrared phase selector over the RS-232
interface and that the proper network
configurations are made to allow the
RMC-30 to be found on the network by
central management software. The unit
must be configured with a static IP
address.
Specify the address type as static.
Specify the IP address to be used by this
device.
Specify the Subnet Mask (usually
255.255.255.0).
Specify the Default Gateway.
Refer to the User’s Guide for instructions
on how to access the configurations via
the internal web pages.
Serial Port Configuration
The Serial Port configuration specifies the
type of transport communications means
which will be used to ferry the RS-232
serial data over the IP network. Central
management software supports TCP
sockets and COM port profiles.
Selection of RawSocket allows the central
management software to connect to the
RMC-30 via a TCP socket connection.
Installation of Tracer IP COM port
redirector software allows the remote
devices to be installed as COM ports on a
PC or server. Tracer IP is sold separately.
GTT has not tested Tracer IP.
Configure the serial port settings as
described in the Required Serial Settings
on page 3.
Raw Socket Configuration
The transport protocol configuration
defines how the serial data is transported
across the network.
Specify Both for Direction.
Specify TCP for the transport.
Compatibility Test Configuration
Device model: RMC-30-HI
Device firmware: Boot v2.13.0, Main
v3.5.0
Comm modes: TCP/IP
Software: Central Management Software
1.5
Phase selector: Opticom Infrared Model
752 / 754
(25 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern